JavaScript is disabled for better experience, JavaScript works in its browser before creating
so you can create YouTube videos on the Internet (in other vehicles) in everything I have done in Here, as I did here, hopefully others found it was a complete revelation. I am not a professional and that cannot meet all your needs, but with my FX4 2011 screws, which contains 230,000 miles as experts, 3000 of us are the room choice How to prevent me? He plans to use equal to 15), Rost Prior, Top Het, then eyeliner is a liter of all he needs. I don't have all the photos on the road, but this is what I have: cut all the old oxides! Be sure and do not cut too much because you need something for the rivet (I used the rivet in this case, instead of welding (before and after the procedure), I had to be preserved by the places Plastic clip with 15 geveer oxide: painted oxide:
*
after liquid oxide is prepared on the floor and metal, I cover the surfaces, cover the surfaces I can achieve with the support of the oxide:
*
The attached taste of 151977i has no assistant. 2-3 inches to adapt to adapt, make sure I can see on the upper right of the cake space is now the corner of the taxi is oxidized. Corner with Bondo, many layers of Bondo are still over time. Mifter:
*
is not illustrated by seams but they have right above the rivet After that, I could attach better photos, where I decided to cut and attract the final class, I used a grain space 80 in my corner crusher with naked metal, that is Rirtur's real score because it is no longer colored! !! After grinding, it is important to use metal preparation here to confiscate metal.
*
*
130 it faded in ultraviolet light. Therefore, the "damage" completion class is necessary? Well, my body talked that it could be a bad idea about drilling losses below to drain water. The factory, because most of them were lost or broken, I used a metal brush to remove oxide and dirt from the frame holes, and use non -continuous ice 3 m to cover it with it with. This thing, it is very sticky, that is. It is thin, so I doubled it in all holes after it was completely its identification card and was completed. I think I want to start again, but I think it looks very good and I hope it will continue for a few years.